I have gotten this question I'm not sure how to go about.
Cyllinder width is not defined
Sphere is not defined
Hole placement is not defined
I'm completely lost on this one. The question dosent take into account if I drill the hole on the lower half of the sphere. It dosent state if the 10 inch is to be measured from the center of the cyllinder.
So I'm thinking the question wants me to explain what considerations needs to be taken in order to make a simulation.
What do you think?
"A cyllinder shaped hole, 10 inches long, is drilled through a sphere.
Explain the remainder of the volume of the sphere."
Explain the remainder of the volume of the sphere."
Cyllinder width is not defined
Sphere is not defined
Hole placement is not defined
I'm completely lost on this one. The question dosent take into account if I drill the hole on the lower half of the sphere. It dosent state if the 10 inch is to be measured from the center of the cyllinder.
So I'm thinking the question wants me to explain what considerations needs to be taken in order to make a simulation.
What do you think?
Last edited: